A Brand New Pocket Bike Needs to Be Broken In, Here’s How
Once you bring home a new pocket bike, there are breaking in procedures that need to be done. It is easy to get excited and want to ride around at top speed but if you do not properly break in the bike you risk cutting the engine life by almost half. That means you will be pouring money to maintain the bike much earlier than you should. There are many techniques to properly break in your new bike but two of the most popular strategies stand out.
The first method of breaking in a new pocket bike is known as heat cycling. It begins by turning on the engine to idle or just above idle for about five or ten minutes. The engine will only be slightly warmed and still cooler than normal operating conditions. Let the engine cool down after the five or ten minutes of idling. Once the engine has cooled down, bring it back up by letting it idle for an additional ten minutes and then turn it off to cool down once more. Do this for a total of four cycles.
Now that the engine has cooled after the final warm up we need to break it in with a little riding. Ride the bike at a slow and easy pace until the tank is emptied. The important thing is to not stress the engine by revving the engine too hard or speeding up too fast. Once the entire tank of gas is done, the bike is ready for normal riding on its next tank.
The second method of breaking in the pocket bike is considered to be more fun because it involves some riding action. First thing is letting the engine idle for about five minutes to warm up a little. Then, slowly bring up the throttle very gently. Bring it up to where the clutch would engage to keep the bike from lurching if there was too much throttle applied during riding.
When you take the bike for the ride, slowly break in the tires by running a lap at a very slow speed. On the second lap, speed up the bike and try to focus on hitting as wide a range of RPMs as possible by accelerating and decelerating frequently.
During the first fifteen minutes of riding try not to push the engine too hard nor ride too slow. It is also important to check that the engine is sufficiently warmed before beginning the second lap. Throughout the ride, make sure the clutch does not engage fully or it will burn. It is obvious when the clutch is fully engaged by the bucking of the engine or the sound it will make.
Now that your bike is ready it is time to hit the tracks hard and appreciate the full potential of your pocket bike. Remember to always follow safety instructions and wear proper gear when riding.
Related posts
| bikes